GE Washing Machine Information

GE Washing Machine Repairs- Model WSL Washing Machine Fault Code - Code IE - This indicates a water level sensor problem. If the water sensor fails to send a signal for a period greater than 5 seconds, the code is activated.

You need tothe on button. If no other buttons will operate 1. Check the wiring harness at the plugs 2. Check the pressure sensor switch 3. Check the program controller circuit board You may need to call the service technician if you cannot locate any obvious faults.

GE Washing-Machine Repairs- Code 7E - This indicates a water supply problem. You need to the on button. If no other buttons will operate 1. Check the wiring harness at the plugs 2. Check the pressure sensor switch 3. Check the program controller circuit board 4. Check water supply valve You may need to call the service technician if you cannot locate any obvious faults. GE Washing-Machine Repairs - Code E - This indicates that water level does not reduce to the reset point within the program period of 15 minutes from draining water out of the washer. You need to the on button. If no other buttons will operate 1. Check the wiring harness at the plugs 2. Check the pump motor 3. Check the program controller circuit board You may need to call the GE-washer service technician if you cannot locate any obvious faults.

GE Washing Machine Repairs - Code dE - This indicates that the lid is open during the wash cycle.

Close the lid, in some cases this can be a faulty switch so open and close the GE-washer lid a couple of times to clear the condition.

1. Check the wiring harness

2. Check the lid switch

3. Check the unbalance switch

4. Check the program controller circuit board


GE Washing Machine Repairs - Code UE - This indicates that drum unbalance switch is activated. The unbalanced load is sensed three times during the period of a spin operation.

You will need to open the lid, redistribute the clothes to rebalance, close the GE-washer lid and restart and if the fault continues check the following

1. Check the wiring harness

2. Check the unbalance switch

3. Check the program controller circuit board

GE Washing Machine Repairs - Code OE - This indicates that there is a water overflow condition. The machine water supply does not cease after the overflow condition is detected.

Turn off the water supply to the washer, unplug your GE-washer electrical power cord.

1. Check the wiring harness

2. Check the water inlet valve

3. Check the pressure sensor switch

4. Check the program controller circuit board

Click on this link to find out more about Appliances and Repairs. Appliance Repairs and all you need to know.

GE Washing Machine Information